reflactaseal_product

ReflectASeal 525

Description:
REFLECTASEAL-525 Pre-Prime removes rust and film, preparing metal surfaces for coating.  The convenient gel formula mixes easily with water.  It reacts with rust and oxide films to restore metal surfaces, leaving a thin film to prevent further rusting.  REFLECTASEAL-525 Pre-Prime removes mineral buildup, water stains, and debris.  It also removes the film that is present on new galvanized metal.

Mixing:
The correct dilution rate is very important!

Mix 1 part REFLECTASEAL-525 Pre-Prime with 20 parts water.  Coverage is approximately 400 to 500 square feet per gallon.  Be sure to consider metal corrugation when determining all material requirements.  Typically increase the square feet by 20% to ensure that enough material is ordered.

Application:
REFLECTASEAL-525 Pre-Prime can be applied using a pump up sprayer or brush.  Remove as much grime, dirt, grit, and sludge as possible before applying REFLECTASEAL-525 Pre-Prime.  Apply at a rate of 400 to 500 square feet per gallon of mixed solution (1 part REFLECTASEAL-525 Pre-Prime to 20 parts water).  After application, agitate the surface with a stiff brush, broom or mop.  Allow 10 minutes for REFLECTASEAL-525 Pre-Prime to penetrate the surface.  Rinse with high pressure fresh water.

Do not leave REFLECTASEAL-525 Pre-Prime on metal surfaces for more than 15 minutes or allow to dry on the surface.

General:
REFLECTASEAL-525 Pre-Prime should be used in well-ventilated areas.  Surfaces should be free of foreign matter.  Apply REFLECTASEAL-525 Pre-Prime at temperatures above 40 F.  Do not apply when freezing may occur.  Surface temperatures should not exceed 150 F and air temperatures should not exceed 100 F.

Safety:
WARNING:  HARMFUL OR FATAL IF SWALLOWED.  CONTACT A PHYSICIAN IMMEDIATELY.  CORROSIVE.  MAY CAUSE BURNS.  Contains phosphoric acid.  Keep out of reach of children.

This product (and any recommended thinners) contains solvents and/or chemical ingredients.  Adequate health and safety precautions should be observed during storage, handling, use, and drying periods.  For safe usage, user is specifically directed to consult the current Material Safety Data Sheet for this product.  When using this product in a confined space or closed area, consult the OSHA or ANSI bulletins on safety requirements.  The information as set forth in the technical data contained herein has been developed based on test and evaluations made by REFLECTASEAL, LLC for standard coating applications.  We believe this information is the best currently available on the subject.  We make no guarantee of results and assume no obligation or liability in connection with this information.  It is offered as possible helpful suggestion, any experimentation you may care to undertake along these lines, is at your own risk.  You should test the coating material to determine if it is suitable for the application intended.
 

For further assistance, contact one our technicians via phone or e-mail.

 For emergency information contact:

CHEMTREC @ 1-800-424-9300